P0442

Fuel evaporative system vapor leakage fault

Free here: what the code means, the symptoms, the causes and where to start.

With a subscription: every step for your exact vehicle, the values to measure and the wiring diagrams.

What a subscription adds

Severity: Critical

WARNING. Before servicing, removing or installing a high-voltage component, you must run the high-voltage shutdown procedure, confirm that the 12 V supply and the high-voltage connectors are disconnected, and leave the vehicle standing for at least 5 minutes after shutdown. Technicians who have not been trained on this model's high-voltage system must not disassemble the high-voltage system (inclu

What are the symptoms of P0442?

  • The instrument cluster reports a DTC

Where do I start with P0442?

Check the engine controller DTCs. Connect VDS to the diagnostic port. Turn the start switch to ON. Scan the ECU modules. Enter the engine controller, read and clear the DTCs. Turn the start switch to OFF and wait a few seconds. Turn the start switch back to ON. Enter the engine controller again and read the DTCs.

The full procedure for your vehicle

Each procedure is written for one vehicle from its service documentation — the steps on a Seal are not the steps on a Han.

Is your vehicle in it?

The full procedure for P0442 is written for these vehicles today:

  • BYD Seal 05 DM-i 2025
  • Denza D9 DM 2022
  • Denza D9 DM-i 2024
  • Denza D9 DM-i 4-Seat 2023-2024
  • Yangwang U8 2023
  • Yangwang U8 2024

Not there yet? Message us and we will tell you when yours is ready.

Worth knowing

  • The vacuum decay gradient of the evaporative system exceeds the threshold.

Which vehicles does P0442 affect?

  • BYD Seal 05 DM-i 2025 procedure ready
  • Denza D9 DM 2022 procedure ready
  • Denza D9 DM-i 2024 procedure ready
  • Denza D9 DM-i 4-Seat 2023-2024 procedure ready
  • Yangwang U8 2023 procedure ready
  • Yangwang U8 2024 procedure ready

The rest of this check — every step for your own vehicle — is for subscribers. Subscribe now